Miele KM 5773 Technical Information page 19

KM 5773
sounds. Select a vacant program slot using the - or + touchpad. Touch pad M
again until a signal tone sounds, first short and then long. Switch the burner
on and start cooking. All steps of the burner taken from this point on and their
precise duration are recorded. During the recording the timer LED associated
with the burner flashes. The recording ends when the burner is switched off
or when touchpad M is pressed again until a signal tone sounds.
The recording is stopped and not saved
 if the stop & go function is activated.
if the entire cooktop is switched off via the main switch .

if the maximum operating time is exceeded (refer to Section 010-2.13).

 in the event of a power break or reset.
2. Confirm a memory program: After recording is finished, the program is
shown in fast motion. The burner display shows the programmed levels in
sequence, and the timer display shows the duration (rounded up to minutes)
for each power level. A recorded program can also be viewed later at any
time: Switch the cooktop on. Touch M. Access the desired program by
pressing the - or + touchpads.
If the recorded program is for a burner where cooking is in progress, the
power level set for that burner continues unchanged, while the burner display
shows the levels of the program.
At the end of the program view, the number of the program is shown again
briefly in the timer display and the cooking burner display goes out. If cooking
is in progress, the cooking burner display again shows the power level set.
3. Use a memory program: To use a recorded memory program, the pot, food
amount and surface area of the food have to be the same as when the
program was recorded. Set a pot with food to be cooked onto the (off) burner.
Switch the cooking burner on. Touch M, then use the - or + touchpads to
select the program. Then touch M again until a signal tone sounds, first short
and then long.
The active burner switches on and then off again at the end of the program
sequence. During the program, the timer LED of the burner flashes, the
burner display shows the respective power level, and in the timer display the
number of the program flashes alternately with the remaining time of the
program. At the end of the program, a signal tone sounds, and the burner
switches off. If a setting of the burner is changed manually during the
program sequence, the program is aborted, and cooking will continue at the
changed setting.
If the stop & go function is activated, the program sequence is stopped; it
continues after stop & go is lifted.
4. Delete a memory program: It is not possible to record over an existing
program. The program has to be deleted to free the program space for a new
entry. To do this, touch M and access the program to be deleted using the -
or + touchpad. Touch the - and + touchpads at the same time until a long
signal tone sounds and the dot behind the program number goes out.
19
Technical Information