Fault Repair; Fault Code Summary - Miele KM 5773 Technical Information

KM 5773
3

Fault Repair

3.1

Fault Code Summary

Cause:
See fault code table.
Fault code
After initial power hookup or after customer service programming - Indication in power
level display: left F, right E
Fault code in timer display
FE + alternating
fault codes 00,
04, 08,12, 16
FE + alternating
fault codes 00,
08, 76
FE + alternating
fault codes 00,
12, 76
FE 40 flashes
After initial power hookup or during adjustment - Indication A in both lower power level
displays, and number for affected sensor in timer display (refer to Figure 010-4)
Fault code in upper power level
display
F1
F2
F3
F4
When switching a burner on - Fault code in the power level display of the affected
burner
F and flash
alternately
During normal operation - Fault code in power level display of a burner
F + beep (3 s
every 30 s, for
10 min)
When recording a memory program - In power level display of the affected burner: F
Fault code in timer display
F 11
F 99
Hardware fault - In power level display: left F, right E
Fault code in timer display
FE 01
FE 02
FE 03
Cause Remedy
Refer to Section 010-3.34
Wrong model
programming
Refer to Section 010-3.18
Surroundings too bright Reduce the bright light in the proximity
Strong pulsating light
Reduce the pulsating light
(fluorescent tube)
Sensor covered with
Remove the item from the control panel
light-colored item
Strong fluctuations
Reduce the fluctuations in the proximity
in surrounding light
Wrong model
Refer to Section 010-3.9
programming
Sensor covered See Sections 010-3.2 and 010-3.55
Number of possible
None. The burner switches off, recording is aborted,
settings for the memory
the appliance is in good working order.
program is exceeded.
Maximum program time
None. The burner switches off, recording is aborted,
for the memory
the appliance is in good working order.
program is exceeded.
Sensor fault, - sensor,
front left
Check sensor for soiling under the ceramic surface
Sensor fault, + sensor,
and clean as necessary. Replace selection
front left
electronic; see Section 010-4.6.
Sensor fault, booster
sensor, front left
25
Technical Information