Thermo Scientific Sorvall RC6 Plus Instruction Manual page 35

Step
1
1. When setting two or more run conditions, there is no need to press the ENTER key after each
setting. The set value is entered by pressing a cursor key and the cursor moves to the new item in
ready-to-enter state.
2. If changing the TIME setting during continuous operation (HOLD), enter a value adding the
desired remaining time to the elapsed time. For example, to stop the operation after 1 hour and 30
minutes when 5 hours have elapsed in continuous operation, turn the TIME display to
ready-to-enter state by pressing a cursor key and enter as follows.
Setting RUN Conditions
The table below exemplifies how to set run conditions such as rotor speed, run time and rotor
temperature.
Thermo Scientific
Key Operation
Press the ROTOR key on the KEY BOARD.
Enter the rotor number to be used with the ten-key
numerical pad and press the ENTER key. (The screen
turns to the next page by pressing the cursor key.)
The screen returns to the RUN SCREEN.
Screen Display and Notices
4
OPERATION
Basic Operation
Sorvall RC6 Plus 4-5