Avaya G350 User Manual page 186

Chapter 16
176
Table 16-8. RIP Interface Parameters (Continued)
Field
IP Address
State
Status
RIP Version
Send Receive Mode
Description
The IP address of the interface.
The operational status of the RIP interface -
active or inactive.
The administrative status of the RIP interface. If
checked, the RIP interface status is enabled. If
unchecked, it is disabled.
The router can be configured to operate either
RIP version 1 or RIP version 2 on each IP
interface. The configuration of the RIP version
must be consistent on each subnet. That is, all
routers should be configured with the same RIP
version on their interface to the subnet.
When possible, homogeneous configuration of
the RIP version in the network is
recommended.
• - The router runs regular RIP on that
Rip1
interface, following the RIP version 1
subnet aggregation rules. That is, it
advertises an aggregate route for the net as
opposed to advertising subnet routes across
the network boundary.
• Rip2 - The router runs RIP version 2 on
that interface. RIP version 2
advertisements are sent as multicast rather
than broadcast. No route aggregation is
done in RIP version 2. RIP version 2 allows
for Variable Length Subnets Masks
(VLSM), meaning that subnets of the same
net may have masks of different lengths,
and may be of different sizes.
What the device sends on this interface. Values
are:
• talk-listen - RIP updates contain the entire
routing table.
• talkDefault-listen
only a single entry. This advertises the
router as the default router.
• - No RIP updates are sent.
listen-only
- RIP updates contain
Avaya G350 Manager User Guide