Backlight Connector (J32); Dual Stacked Dp Connector (Display Port) (J2); Table 15: 7-Pin Backlight Connector; Table 16: Dual Stacked Dp Connector - Kontron Qseven-Eval Carrier User Manual

7.3. Backlight Connector (J32)

Figure 11: 7-pin Backlight Connector

Table 15: 7-pin Backlight Connector

Pin Signal
1 NC
2 Backlight Brightness 5V or 3.3V (jumper selection J24) PWM (0%
- 100%)
3 GND
4 V_BKLT - 12V or 5.0V (jumper selection J25)
5 V_BKLT - 12V or 5.0V (max. 12W continuous, inrush limited with
U36 or U35)"
6 GND
7 Backlight enable (0 V: off; 5 V or 3 V3: on )

7.4. Dual Stacked DP Connector (Display Port) (J2)

The connector provides DP signals from the QSEVEN board as an option on LVDS pins.

Figure 12: Dual Stacked DP Connector

Table 16: Dual Stacked DP Connector

Pin Signal
1 OUT
2 GND
3 OUT
4 OUT
5 GND
www.kontron.com
Type
NC
Out (27.4 Ohm series resistor)
Ground
Power
Power
Ground
Out (27.4 Ohm series resistor)
Description
ML_Lane0+_TOP
GND_P2
ML_Lane0-_TOP
ML_Lane1+_TOP
GND_P5
QSEVEN-Eval Carrier - Rev. 1.1
// 32