Table of Contents
Advertisement
LEDs
SMD LEDs for storage activity, board status, device and power status (power good)
Internal Header and Jumper
GPIO/LPC
GPIO/LPC Header 2.54 mm
Power
2.54 mm pin header, dual row
Management
Header
SYS Signals Header
2.54 mm pin header, dual row
Battery
1.5F Goldcap and/or CR2032 battery. Optional parallel usage supported.
CPU Fan
4-pin fan connector, Voltage can be 5 V or 12 V (default)
SYS Fan
3-pin fan connector, Voltage can be 5 V or 12 V (default)
Carrier Board Controllers
I2C EEPROM
General purpose EEPROM I2C
SPI Socket
SPI socket with 16 MB Flash
HDA Codec
TSI 92HD73C HDA Codec
I2S Codec
WM8904 I2S Codec
EEPROM DDC
Holding display relevant DDC information. Used by BIOS to initialize LCD.
Carrier Board Power
Power Input
12 V input power connector, used as an alternative power for module to support wide
voltage range. 12 V DC power connector for powering carrier and module 5 V. Separate input
power connector for module with voltage range: 3.0 V to 5.25 V DC
Optional 24-pin ATX Power Supply
LED status
Power LEDs
Power good of carrier power lanes
CARRIER_PWR_ON
Power on
CARRIER_STB#
CARRIER_STB#
LVDS V_BKLT
5V, 12V indication LVDS backlight
Ethernet LEDs
Ethernet status
HDA/I2S LEDs
HDA / I2S Audio codec indication LEDs
mPCIE mode
WPAN#, WLAN#, WWAN# indication
SATA_ACT#
SATA activity LED
Power rails
1.8 V; 3.3 V; 5 V
GPIO
GPIO indication LEDs
Watchdog
Watchdog indication LED
Danger of explosion if the lithium battery is incorrectly replaced.
www.kontron.com
Replace only with the same or equivalent type recommended by the manufacturer
Dispose of used batteries according to the manufacturer's instructions
QSEVEN-Eval Carrier - Rev. 1.1
// 18
Advertisement
Table of Contents
