4.2. Component Main Data; Table 1: Component Main Data - Kontron Qseven-Eval Carrier User Manual

4.2. Component Main Data

The table below summarizes the features of the motherboard.
Table 1: Component Main Data
Qseven-Eval Carrier
Form factor Carrier board with 210 mm x 200 mm.
Memory
EEPROM System The EEPROM type 24LC64 on carrier board connected to QSEVEN GP I2C or SM bus.
(U71)
SPI flash socket SPI flash socket (SOIC8 – 1045-8636) with flash memory W25Q128
(J63)
EEPROM DDC The EDID EEPROM type 24C04 on carrier board connected to LVDS_I2C bus. Holding display
optional relevant DDC information. Used by BIOS to initialize LCD. KEAPI support with module.
(U32)
External I/O
LAN 1x Gbit-Ethernet port
USB 2x USB 3.0 double stack and 1x μUSB connector for On The Go (OTG) function: powered for
host, not powered for client. The 5 V output from USB 2.0 and USB OTG is separately
electronically fused to 500 mA. The 5V output from USB 3.0 is electronically fused to 1000
mA each port.
HDMI HDMI connector from QSEVEN module
DP++ DP++ connector from QSEVEN module
COM1 COM RS232, 9-pin DSUB
Audio Line-in and line-out 3.5 mm jack; Front Panel 2x5 Pin Header (2.54 mm), supporting both
interfaces I2S and HDA selectable by jumper.
Internal I/O
LVDS 30-pin LVDS dual channel from QSEVEN module. Configurable 3.3 V / 5V voltage levels of
power for different panels via jumper.
Backlight Backlight PWM and power. Configurable 12 V/ 5 V voltage levels of backlight power for
different panels via jumper. Maximum Power is 12 W continuous. If the selected panel
exceeds, the provided power by this carrier evaluation of the QSEVEN module with LVDS
can still be done with external panel power.
eDP eDP connector, shared with LVDS as an option selectable by jumper. PWR Out must provide
+3.3 V +/-10 % with a maximum current of 500 mA and a minimum power capability of 1.5
W.
mSATA 1x slot (full size / half size ; SATA port)
LVDS One dual-channel LVDS. This is muxed with eDP0/eDP1 (jumper selectable) as per Qseven
specification.
PCIe X1 Two PCIe X1 slots
mPCIe Two card slots (full size / half size) - PCIe & USB; support all MC3 mPCIe cards
SIM Card SIM Card connected to both mPCIe
μSD microSD card socket from QSEVEN module
Controller Area CAN interface
Network (CAN)
www.kontron.com
QSEVEN-Eval Carrier - Rev. 1.1
// 17