Electric Seat Height Adjustment - Otto Bock skippi Instructions For Use Manual

Accessories
NOTICE
Damage due to improper use of the electric seat op-
tions.
„ When using electric seat options, note that the seat
function actuators are not designed for continuous use,
only for short-term use under limited loads (10 % load,
90 % idle time).
„ Observe the following guidelines: at maximum load ca-
pacity, 10 seconds of activation time must be followed
by approx. 90 seconds of idle time. The electric seat
functions are considered independently of the driving
function for this purpose.
„ Only activate the electric seat functions if no fault or
error is present.
INFORMATION
Bring the seat to a level position when getting into or out of
the power wheelchair.
INFORMATION
For safe operation, please also observe the information in
section 2.3 "General safety instructions" and section 2.5
"Safety requirements for operation".
68 | Ottobock

7.2.2 Electric seat height adjustment

WARNING
Risk of falling due to improper use of the seat height
adjustment feature.
„ Drive in street traffic only with the seat height adjust-
ment lowered.
„ Use the seat height adjustment feature only with the
backrest in the upright position.
„ When driving with the seat height adjustment feature
raised, fasten the belts (lap belt, four-point belt) and do
not lean out beyond the seat surface.
„ Ensure that creep speed is activated when the seat
height adjustment function is used. If this is not the
case, contact a specialist dealer immediately. Only use
the power wheelchair with the seat height adjustment in
its lowest position until the fault is repaired.
NOTICE
Damage due to lack of maintenance of the seat height
adjustment feature.
„ Inspect the seat height adjustment feature for visible
signs of damage at least 1 x per month and ensure all
screw connections are tight.
„ Check for correct tyre pressure.
Skippi