Power Seat Height Adjustment - Otto Bock Juvo Instructions For Use Manual

Use

6.11.2 Power seat height adjustment

WARNING
Improper use of the seat height adjustment feature
Falling, tipping over due to user error
► Use the seat height adjustment feature only with the backrest in the upright position.
► Drive in street traffic only with the seat height adjustment lowered.
► Even when driving indoors, fasten the belts and do not lean out beyond the seat surface when the seat height
adjustment feature is raised.
► Ensure that creep speed is activated when the seat height adjustment function is used. If this is not the case,
contact a specialist dealer immediately. Only use the power wheelchair with the seat height adjustment in its
lowest position until the fault is rectified.
NOTICE
Risk of transportation damage
Damage to the product through user error
► Always lower the seat height adjustment feature fully for loading or transportation.
INFORMATION
► Also observe the safety instructions in the section "Power seat functions" (see Page 55).
► Observe the instructions for use in the sections "Controlling power seat functions" (see Page 58) and "Joy­
stick functions" (see Page 59).
43
VR 2 control unit
Display
R-Net control unit – TEN° control panel
Symbol
56
Information
Restricted speed (creep speed)
INFORMATION: The [Selected speed level] LED display flashes.
Information
Restricted speed (creep speed)
Turtle symbol lights up yellow: automatic speed reduction (e.g. because a seat
function was activated)
The power seat height adjustment feature raises the
seat bottom by 350 mm (13.8") using a motor drive.
The seat can be moved up continuously to the height
specified.
The driving function can be used indoors even when the
seat is raised. The speed is decreased when the seat is
raised.
This is indicated on the control panel as follows:
Juvo