LinMot E1100-CO Drive Data Sheet & Installation Manual page 19

Installation Guide E1100
X6: Digital I/O (only available on E1100-GP (-HC, -XC))
DSUB-25 (f) All Inputs:
Direct interfacing to digital 24VDC PLC outputs.
Input Current:
Low Level:
All Outputs:
Short circuit and overload protected high side switches
Voltage:
Max. Current:
Outputs may directly drive inductive loads. Do not connect any capacity because of the peak current!
X7 - X8 RS485/CAN
RJ-45 Use twisted pair (1-2, 3-6, 4-5, 7-8) cable for wiring.
The built in CAN and RS485 terminations can be activated by S3.2 and S3.3.
X7 is internally connected to X8 (1:1 connection)
X9: Profibus DP (only available on E1130-DP (-HC, -XC))
NTI AG, LinMot
1mA
-30 to 8.5VDC
24VDC
100mA
1 RS485_Rx+
2 RS485_Rx-
3 RS485_Tx+
4 GND
5 GND
6 RS485_Tx-
7 CAN_H
8 CAN_L
case Shield
1 Not connected
2 Not connected
3 RxD/TxD-P
4 CNTR-P
5 GND
6 +5V
7 Not connected
8 RxD/TxD-N
9 Not connected
case Shield
Installation Guide E1100 23/08/2018
Sample Rate: 1ms
High Level: 20.5 to 30VDC
Update Rate 1ms
Peak Current: 370mA (will shut down if exceeds)
A
B
Y
Z
(isolated)
(isolated)
Page 19/27