LinMot E1100-CO Drive Data Sheet & Installation Manual page 16

Motor wiring for Phase Currents below 5A RMS 7.5A peak
Important:
Motor phases may only be connected to X3 if RMS current is below 5A and peak current is below 7.5A.
For UL applications the motor phases have to be wired on X2 and not on X3!
X4: 12pin Control/Supply (E1130-DP(-HC,-XC), E1100-CO(-HC,-XC), E1100-DN(-HC,-XC), E1100-RS(-HC,-XC))
Phoenix
Inputs (X4.3 .. X4.12):
MC1,5/12-STF-
Outputs (X4.4 .. X4.11):
3,5
Brake Output (X4.3):
Input X4.12: SVE (PowerStageEnable) must be high for enabling the power stage. If it goes low for more
than 0.5ms the PWM generation of the power stage is disabled by hardware.
Supply 24V / typ. 400mA / max. 2.1A (if all outputs "on" with max. load.)
- Tightening torque: 0.25Nm (2.2 lbin)
- Screw thread: M2
- Use 60/75 °C copper conductors only
- Conductor cross-section: 0.5 - 1.5mm
Internal Fuse (F2): 3A slow blow (Schurter OMT125, 3404.0118.xx, UL File Number: E41599)
The fuse is directly soldered onto the PWB. Replacement is only possible by qualified personnel with
appropriate equipment.
CAUTION: For continued protection against risk of fire, replace only with same type and rating of fuse.
Page 16 of 27
12 Input SVE
11 I/O X4.11
10 I/O X4.10
9 I/O X4.9
8 I/O X4.8
7 I/O X4.7
6 I/O X4.6
5 I/O X4.5
4 I/O X4.4
3 I/O X4.3/Brk
2 +24VDC Supply
1 GND Supply
24V / 5mA (Low Level: –0.5 to 5VDC, High Level: 15 to 30VDC)
24V / max.100mA, Peak 370mA (will shut down if exceeds)
24V / max.1.0A
2
Installation Guide E1100 23/08/2018
Installation Guide E1100
Power Stage Enable (HW Enable)
Configurable IO, PTC2 Input
Configurable IO, PTC1 Input
Configurable IO
Configurable IO
Configurable IO, Analog Input for EasySteps
Configurable IO, Trigger Input
Configurable IO
Configurable IO, Analog Input
Configurable IO, Brake Driver 1A
Logic Supply 22-26 VDC
Ground
(AWG 21 - 14)
NTI AG/ LinMot/