Table of Contents
Advertisement
Figure 11.4: Graphical visualization: Beam-stream display
DIAGNOSIS
11.4.5
function
DIAGNOSIS
The
• Reset device, i.e., restart the connected light curtain
• Store configuration in non-volatile memory (see chapter 11.4.3)
Sensor Studio
11.4.6 Exiting
After completing the configuration settings, close the
Exit the program via File > Exit.
Save the configuration settings as a configuration project on the PC.
You can open the configuration project again at later time via File > Open or via the
Wizard (
).
Leuze electronic
function offers the following commands.
Connecting to a PC – Sensor Studio
Sensor Studio
configuration software
CSL 710
Sensor Studio
Project
75
Advertisement
Table of Contents
