Table of Contents
Advertisement
Level 0
Level 1
Main Settings
Commands
Operational setting
Select Main Settings > Operational Settings > Filter Depth.
8.5.4
Defining the display properties
With these configurations for the display, the brightness and a time unit for darkening the display are
defined.
Visibility:
• Off: no display; the display remains dark until a button is pressed.
• Dark: text is only slightly visible.
• Normal: text is visible with good contrast.
• Bright: text appears very bright.
• Dynamic: The display darkens gradually over the number of seconds configured under Time Unit (s).
During this time span, the display passes through all levels, from bright to off.
After approx. 5 minutes without button actuation, configuration mode is exited and the display
changes to the previous mode.
When configuring the Visibility in the dark, normal and bright modes, the display is completely
inverted after approx. 15 minutes to prevent the LEDs from burning in.
When configuring the Time Unit (s), you can enter values of up to 240 seconds. Values above
240 (to 299) are not accepted and must be entered again.
The structure of these configurations in the receiver control panel menu is as follows:
Level 0
Level 1
Display
Language
Operating
mode
Visibility
Time Unit (s)
Select Display > Visibility.
Select Display > Time Unit (s).
8.5.5
Changing the language
The system language can be configured with this configuration.
The structure of the configuration in the receiver control panel menu is as follows:
Leuze electronic
Level 2
Description
Teach
Filter Depth
(enter value)
min = 1
max = 255
Level 2
Description
English
Process mode
Off
(enter value)
min = 1
max = 240
CSL 710
Starting up the device - Basic configuration
Reset
Factory settings
German
French
Italian
Alignment
Dark
Normal
Bright
Spanish
Dynamic
53
Advertisement
Table of Contents
