Table of Contents
Advertisement
11
Connecting to a PC –
Sensor Studio
The
graphical user interface for the operation, configuration and diagnosis of sensors with IO-Link configuration
interface (IO-Link devices), independent of the selected process interface.
Each IO-Link device is described by a corresponding IO Device Description (IODD file). After importing the
IODD file into the configuration software, the IO-Link device connected to the IO-Link USB master can be
operated, configured and checked – conveniently and in multiple languages. An IO-Link device that is not
connected to the PC can be configured offline.
Configurations can be saved and reopened as projects for transferring back to the IO-Link device at a later
time.
Only use the
Leuze electronic.
Sensor Studio
The
lish, French, Italian and Spanish.
The FDT frame application of the
be supported in the IO-Link device DTM (Device Type Manager).
Sensor Studio
The
• Make individual configuration settings for the light curtain in the Device Type Manager (DTM).
• The individual DTM configurations of a project can be called up via the frame application of the Field
Device Tool (FDT).
• Communication DTM: IO-Link USB master
• Device DTM: IO-Link device/IODD for CSL 710
NOTICE
Configuration changes only via the control!
Always perform the configuration for process mode via the control and, if applicable, the interface.
In process mode, only the configuration conveyed via the control is active. The configuration changes
Sensor Studio
made via
control.
Procedure for the installation of the software and hardware:
Sensor Studio
Install the
Install the driver for the IO-Link USB master on the PC.
Connect the IO-Link USB master to the PC.
Connect the CSL 710 (IO-Link device) to the IO-Link USB master.
Install IO-Link device DTM with IODD file for CSL 710 in the
11.1
System requirements
Sensor Studio
To use the
Leuze electronic
Sensor Studio
configuration software – in combination with an IO-Link USB master – provides a
Sensor Studio
configuration software is offered in the following languages: German, Eng-
Sensor Studio
configuration software is designed according to the FDT/DTM concept:
are only active in process mode if they were previously transmitted 1:1 to the
configuration software on the PC.
configuration software, you need a PC or laptop with the following specifications:
configuration software for products manufactured by
supports all languages; all languages may not
Sensor Studio
CSL 710
Connecting to a PC – Sensor Studio
FDT frame.
68
Advertisement
Table of Contents
