Table of Contents
Advertisement
NOTICE
Configuration for process mode only via the control!
Always perform the configuration for process mode via the control and, if applicable, the interface.
In process mode, only the configuration conveyed via the control is active. The configuration changes
Sensor Studio
made via
control.
Teach
•
: The sensitivity of the teach event (see chapter 8.2 "Teaching the environmental conditions")
can only be set via the
Upload device data set from device
•
device manager (DTM), e.g., to update the online view in
changed via the receiver control panel.
Upload device data set from device
•
• If the [Upload device data set from device] button (
(DTM), the
• If the [Synchronize with device] button (
Sensor Studio
If parameters are changed in the device manager (DTM) that affect other parameters (e.g., if
changing the beam mode causes the configured logical beams to change), the changes to these
parameters are configured in the device – but are not yet displayed in the
Click on the [Synchronize with device] button (
the current configuration of the light curtain. Following successful synchronization, the [Upload
device data set from device] button (
PROCESS
11.4.4
function
Process
• The
tain.
• [Cyclical refresh] button (
cally depicted under
display covers up to 300 seconds.
Beam-stream display
•
graphical cursor in the visualization, e.g., to evaluate the time difference between two events.
Leuze electronic
are only active in process mode if they were previously transmitted 1:1 to the
Sensor Studio
(
(
Sensor Studio
display shows the current configuration of the light curtain.
display is not consistent with the current configuration of the light curtain.
function offers graphical visualizations of the process data of the connected light cur-
): Starts the cyclical acquisition of the process data, which are graphi-
Numerical display
: Using the [Show or hide the graphical cursor] button (
configuration software.
): The configuration is uploaded from the device to the
Sensor Studio
Synchronize with device
) /
) is displayed in the device manager
) is displayed in the device manager (DTM), the
) to synchronize the
) is displayed in the device manager (DTM).
Beam-stream display
,
and Areas and outputs. Each graphical
CSL 710
Connecting to a PC – Sensor Studio
after the configuration was
(
):
Sensor Studio
Sensor Studio
), you can move the
display.
display with
74
Advertisement
Table of Contents
