Functions Offered In 10Dm - Mitsubishi MELSEC-F FX-10DM-E User Manual

FX-10DM-E DISPLAY MODULE
4.2

Functions offered in 10DM

The table below shows all functions for display and environmental setting offered in the 10DM.
For the detailed contents of display and setting, refer to the corresponding reference paragraph.
Table 4.1:
Classification
Display
Display
Allows to set, in the unit of line, monitoring of up
to 8 items among the messages, comments (in
Katakana characters) and word devices (D, T
and C) set by the user.
Allows to change the current value (D, T and C)
and the set value (T and C) of word devices.
•
1: ENTRY MONITOR
•
Allows to select word devices (D, T and C) of the
PLC, and monitor and change the current value
2: DEVICE MONITOR (D, T and C) and the set value (T and C).
Up to 2 data registers (D), 1 timer (T) or 1
counter (C) can be monitored at a time.
Description on major functions
Message
Arbitrary characters (ASCII codes) are dis-
played in data registers (D) of the PLC.
Comment
Comments (referred to as "Katakana com-
ments" or "device comments" depending on
the sequence programming tool) created by
the sequence programming tool are displayed.
"SYSTEM MODE" Menu 4
Reference
6.2
6.4
4-3
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
4."SYSTEM
MODE"
Menu
5.Environ-
mental
Setting
"MONITOR
SET"
"OTHER"
6.Display
"ENTRY
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list