Table of Contents
Advertisement
FX-10DM-E DISPLAY MODULE
6.5.6
Reset of word devices
This paragraph describes the procedure to reset the current value of a data register (by writing
"K0" to it).
Target devices: D, DD, T (current value) and C (current value)
If a word device to be reset uses a data register (D), timer (T) or counter (C) in a sequence program
(especially when it uses a data register), the word device may not be overwritten.
In such a case, the program may set some data to the word device using the MOV instruction, etc. in the
program.
The word device reset function described in this paragraph is effective to all word devices in principle,
but is practically suitable to reset of the current value of counters (C).
Display Function 6
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
4."SYSTEM
MODE"
Menu
5.Environ-
mental
Setting
"MONITOR
SET"
"OTHER"
6.Display
"ENTRY
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list
6-29
Advertisement
Table of Contents
