Table of Contents
Advertisement
FX-10DM-E DISPLAY MODULE
6.5.4
Change of sign (+ or -) of data
This paragraph describes the procedure to change the sign of the data to minus (-) or plus (+).
Target devices: D, DD and C (C200 to C255)
Display Function 6
You can set the sign by increasing or
decreasing the numeric value by pressing
the [L] or [M] key. However, it takes consid-
erable time to set a large numeric value.
[L] Current value [M]
← -2 ← -1 ← 0 → 1 → 2 →
[Cautions on key operation]
When you change the sign by pressing the
[L] or [M] key then press the [L] or [M] key,
the 10DM performs the following operation.
For example, when you have set the sign to
minus (-) by mistake and would like to
return the sign to plus (+):
When you have set the sign to minus by
pressing the [M] key then press the [L] key,
the cursor "❚" moves to the lowest digit.
Press the [FNC] key to move the cursor to
the sign digit, then press the [L] key.
The 10DM is so designed that the cursor
moves to the lowest digit if you have
changed the sign by pressing the [L] or [M]
key then press another key.
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
4."SYSTEM
MODE"
Menu
5.Environ-
mental
Setting
"MONITOR
SET"
"OTHER"
6.Display
"ENTRY
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list
6-27
Advertisement
Table of Contents
