Table of Contents
Advertisement
FX-10DM-E DISPLAY MODULE
Notes Regarding the use of DM Units
General notes on the use of Communication Cables
Any device which utilizes a data communication function is susceptible to the wider effects of
local EMC noise. Therefore, when installing any communication cables care should always be
taken with the routing and location of those cables. The DM units identified on the previous page
are compliant with the EMC requirement when the following communication cables are used :
Table 0.1:
DM Unit
From version A
FX-10DM-E
(JY309C24571A) of
the FX-20P-CAB0/EN
When using the FX-20P-CAB0/EN cable the Earth Strap must be connected to a suitable earth
point.
Ex. 1
FX-20P-CAB0
40mm
Programmable
Controller
New Cables
Existing Cables
FX-20P-CAB0 modified
as shown in EX.1
F
E
DM units
This cable need to be independently
tested by the user to demonstrate EMC
compatibility when they are used with
Mitsubishi DM units and Programma-
ble Controllers.
E = Additional earth strap connected to the cables
shield. Free end of the earth strap must be
connected to an earth point.
F = Ferrite core
Ex. Tokin - ESD-R-14S or similar
User Made Cables
Advertisement
Table of Contents
