To Install The Machine; Timing Of The Looper To The Needle; Needle Height - KANSAI SPECIAL PX302-4W Instruction

4 4 4 4 - - - - 2 2 2 2 To install the machine

To install the machine To install the machine To install the machine
Install the brackets on the underside of the table board (see the illustration below).
Fit the rubber cushions onto the brackets.
Mount the machine head on the rubber cushions correctly.
【5】TIMING OF THE LOOPER TO THE NEEDLE

5 5 5 5 - - - - 1 1 1 1 Needle height

Needle height
Needle height Needle height
When the needle bar is at the top of its stroke, there
should be a distance of approximately 10mm from
the top surface of the needle plate to the point of
the needle.
screws A.
< Note >
After the above adjustment is made, check to make
sure each needle drops correctly into the center of
each needle drop hole.
Adjustment is made by loosening
＜ ＜ ＜ ＜ M M M M o d e l o d e l ： ： ： ： 3 0 2 o d e l o d e l
5
3 0 2 - - - - 4 W , 3 0 2 3 0 2 3 0 2 4 W , 3 0 2 - - - - 5 W 4 W , 3 0 2 4 W , 3 0 2 5 W ＞ ＞ ＞ ＞ 5 W 5 W