Machine Speed; Machine Speed & Direction In Which The Machine Pulley Runs; Motor & Belt - KANSAI SPECIAL WX Series Instruction Manual

Thread tension should be changed according to various kinds of conditions such as the
thread to be used and/or the feeding amount (see Chapter 10 for "Stitch formation").
【2】MACHINE SPEED
2 2 2 2 - - - - 1 Machine speed & direction in which the machine pulley runs 1 Machine speed & direction in which the machine pulley runs 1 Machine speed & direction in which the machine pulley runs 1 Machine speed & direction in which the machine pulley runs
Refer to the table below for maximum and standard
speeds of the Series. To extend machine life, run the
machine approximately 15~20% below the maximum
speed for the first 200 hours of operation (approx. 1
month). Then run the machine at the standard speed.
The machine pulley turns clockwise as the handwheel
does as seen from the machine pulley.
2 2 2 2 - - - - 2 Motor & belt 2 Motor & belt 2 Motor & belt 2 Motor & belt
Motor : 3-phase, 2-pole, 400W clutch motor
Belt : M type V belt
Select the proper motor pulley according to the
machine speed (refer to the motor pulley outer
diameter on the table below).
position the motor by pressing the finger onto the
middle of the belt so that 1~2cm deflection can be
obtained (see the illustration on the right).
< Machine speed >
TYPE
WX8803
WX8803EMK
LX5801
< Motor pulley selection table >
Motor pulley
outer diameter
(mm)
80
90
100
110
120
130
140
150
Adjust where to
MAXIMUM SPEED
6000SPM
5000SPM
6500SPM
Machine speed (SPM)
50Hz 60Hz
3300 3900
3700 4400
4100 4900
4500 5400
5000 5900
5300 6400
5800 (6900)
6200
STANDARD SPEED
5500SPM
4500SPM
6000SPM
2