Needle Drop And Needle Side Stroke; To Install The Looper - KANSAI SPECIAL PX302-4W Instruction

5 5 5 5 - - - - 2 2 2 2 Needle drop and needle side stroke

Needle drop and needle side stroke Needle drop and needle side stroke Needle drop and needle side stroke
The needle side stroke on this machine is 5.55mm (302-4W) and 7.4mm (302-5W).
To increase the stroke, loosen screw B and move it up in the slot. To decrease the stroke,
loosen screw B and move it down in the slot. The point of the needle should be centered
left to right between fingers of the needle plate when the needle drops to the needle plate.
Adjustment is made by loosening screw C. The needle side stroke movement should
start when the point of the needle moves up from the top surface of the needle plate.
The needle side stroke movement should stop when the point of the needle reaches the top
surface of the needle plate. This timing adjustment is made by worm gear D. To adjust
the position of the needle drop, loosen screws A and turn the needle bar as required.
＜ ＜ ＜ ＜ M M M M o d e l o d e l o d e l ： ： ： ： 3 0 2 o d e l 3 0 2 - - - - 4 W 3 0 2 3 0 2
< Note >
Position of the needle drop 1, 2, 3, 4 from
the left side, 4 is the extreme right end.
4, 5, 6, 1 from the right side

5 5 5 5 - - - - 3 3 3 3 To install the looper

To install the looper To install the looper To install the looper
To set the angle and height of the looper, insert the looper fully into looper holder A and
tighten screw B.
＜ ＜ ＜ ＜ M M M M o d e l o d e l ： ： ： ： 3 0 2 o d e l o d e l
4 W ＞ ＞ ＞ ＞ 4 W 4 W
3 0 2 - - - - 4 W 3 0 2 3 0 2 4 W ＞ ＞ ＞ ＞ 4 W 4 W
＜ ＜ ＜ ＜ M M M M o d e l
< Note >
Position of the needle drop 1, 2, 3, 4, 5 from
the left side, 5 is the extreme right end. 5,
6, 7, 8, 1 from the right side
＜ ＜ ＜ ＜ M M M M o d e l
6
o d e l ： ： ： ： 3 3 3 3 0 2 o d e l o d e l 0 2 0 2 - - - - 5 W 0 2 5 W ＞ ＞ ＞ ＞ 5 W 5 W
o d e l o d e l ： ： ： ： 3 0 2 o d e l 3 0 2 - - - - 5 W 3 0 2 3 0 2 5 W ＞ ＞ ＞ ＞ 5 W 5 W