Machine Speed; Machine Speed & Direction In Which The Machine Pulley Runs; Motor & Belt; Attaching Direct Motor - KANSAI SPECIAL DFB MR-S Series Parts List, Instructions

■ Threading diagram for DFB1404
4
【3】MACHINE SPEED
MR-S
3-1 Machine speed & direction in which the machine pulley runs
Refer to the table below for maximum and standard
speeds of the Series.
To extend machine life, run the
approximately 15~20% below the maximum speed for
the first 200 hours of operation (approx. 1 month).
Then run the machine at the standard speed. The
machine pulley turns counterclockwise as seen from
the end of the machine pulley.
3-2 Motor & belt
Motor : 3-phase, 2-pole, 400W clutch motor
Belt : M type V belt
Select the proper motor pulley according to the
machine speed (refer to the motor pulley outer
diameter on the table below).
Adjust the position of the motor by pressing the finger
onto the middle of the belt so that 1~2cm deflection can be achieved (see the illustration on
the right).
< Machine speed >
Model Maximum speed
DFB1402MR-S 3500
< Motor pulley selection table >

Machine speed

(SPM)
Motor pulley outer
diameter (mm)
50Hz 60Hz
60 2500 2950
70 2900 3450
80 3300 3900
90 3700 4400

3-3 Attaching direct motor

This product includes bracket ① and washer ② for attaching Ho Hsing brand direct drive
motor. Direct motor is sold separately. (Parts No. 59-060 Ho Hsing brand i70 110-240V dual
voltage direct motor or Parts No. 59-037 Ho Hsing brand GD60 200-240V direct motor)
Please refer below drawing for
attaching direct motor.
5
machine
Standard speed
3000
②
①
remove
MR-S