Threading; Machine Speed; Machine Speed & Direction In Which The Machine Pulley Runs - KANSAI SPECIAL SX Series Instructions Manual

2-3 Threading

2-3 Threading
Thread the machine correctly by referring to the illustration below. Thread the machine correctly by referring to the illustration below.
To thread the loopers, lay the looper holder down using the looper drawing device. To thread the loopers, lay the looper holder down using the looper drawing device.
■To lay the looper holder down ■To lay the looper holder down
When the needle bar is at the bottom of its stroke, press push button G. When the needle bar is at the bottom of its stroke, press push button G.
Threading is easy. Threading is easy.
A，B，C .. Needle threads
D，E，F .. Looper thread
【3】MACHINE SPEED 【3】MACHINE SPEED
3-1 Machine speed & direction in which the machine pulley runs
Maximum speed : 4,500 spm (4,000 spm for normal use)
< Note >
Run the machine at 3,500 spm for the first 200 hours
(approximately 1 month) for durability.
The handwheel turns counterclockwise as shown in
the illustration.
2