Machine Speed; Machine Speed & Direction In Which The Machine Pulley Runs; Motor & Belt - KANSAI SPECIAL PX302-4W Instruction

【2】MACHINE SPEED
2 2 2 2 - - - - 1 Machine speed & direction in which the machine pulley runs 1 Machine speed & direction in which the machine pulley runs 1 Machine speed & direction in which the machine pulley runs 1 Machine speed & direction in which the machine pulley runs
Maximum speed : 3,500 rpm
Standard speed : 3,000 rpm
To extend
approximately 15~20% below the maximum speed
for the first 200 hours of operation (approx. 1
month). Then run the machine at the standard
speed.
The machine pulley turns counterclockwise as
seen from the end of the machine pulley (see the
illustration).
2 2 2 2 - - - - 2 Motor & belt 2 Motor & belt 2 Motor & belt 2 Motor & belt
Motor : 3-phase, 2-pole, 400W clutch motor
Belt : M type V belt
Select the proper motor pulley according to the
machine speed (refer to the motor pulley outer
diameter on the table below). Adjust the position
of the motor by pressing the finger onto the middle
of the belt so that 1~2cm deflection can be
achieved (see the illustration).
< Motor pulley selection table >
Motor pulley
outer diameter
(mm)
60
70
80
90
machine life, run
Machine speed (SPM)
50Hz 60Hz
2500 2950
2900 3450
3300 (3900)
(3700) (4400)
the machine
2