Position Of The Presser Foot And Foot Lift; Adjusting The Stitch Formation; Adjusting The Looper Thread Eyelets - KANSAI SPECIAL PX302-4W Instruction

8 8 8 8 - - - - 2 Position of the presser foot and foot lift

2 Position of the presser foot and foot lift 2 Position of the presser foot and foot lift 2 Position of the presser foot and foot lift
The presser foot should not touch the needle.
Adjustment is made by loosening screw A and then
moving the presser foot to the right or left.
■ Foot lift
Fit the collar onto the bushing with the presser foot
9mm above the top surface of the needle plate.
Then tighten screw B.
【9】ADJUSTING THE STITCH FORMATION

9 9 9 9 - - - - 1 Adjusting the looper thread eyelets

1 Adjusting the looper thread eyelets 1 Adjusting the looper thread eyelets 1 Adjusting the looper thread eyelets
Align the eyes on the looper thread eyelets A with
the center line of the shaft. Adjust looper thread
eyelets A according to sewing conditions such as the
fabric or thread to be used by loosening screws B.
To increase the amount of the thread to be supplied,
move the eyelets backward.
amount of the thread to be supplied, move the
eyelets frontward.
6~7mm above the guide plate.
made by loosening screw D.
To decrease the
Thread guide C should be
Adjustment is
11