Eccentric For Adjusting The Looper Left To Right; Position Of The Looper Rocker - KANSAI SPECIAL PX302-4W Instruction

5 5 5 5 - - - - 4 Eccentric for adjusting the looper left to right

4 Eccentric for adjusting the looper left to right 4 Eccentric for adjusting the looper left to right 4 Eccentric for adjusting the looper left to right
To adjust the position of the eccentric, loosen screws D.
Align the screw which comes second in the turning
direction of the eccentric with the mark on the shaft.
Then tighten screws D temporarily.
fine adjustment so that the looper shaft can reach the
extreme right end of its travel while the needle is at
the bottom of its stroke with position 4. After this
adjustment, tighten the screws securely.
PX302-5W, adjust each looper shaft to come the same
position while the needle is at the bottom of its stroke with position 3 and position 7.

5 5 5 5 - - - - 5 Position of the looper rocker

5 Position of the looper rocker 5 Position of the looper rocker 5 Position of the looper rocker
The setting distances of the looper with the needle at
position 4 and position 1 should be equal (5.5mm) (For
PX302-5W, the needle at position 1 and position 5) (see
5-2). To achieve this adjustment, loosen screw A to
loosen the collar. Loosen screws B and C.
Then adjust looper rocker D and lever E.
■ Example
If the setting distance with the needle at position 1 is 5mm and the setting distance with
the needle at position 4 is 6mm, move looper rocker D approximately 1mm to right.
After the adjustment is made, tighten screws B and C securely. Then tighten screw A
with the collar fitted onto looper rocker D.
＜ ＜ ＜ ＜ M M M M o d e l o d e l ： ： ： ： 3 0 2 o d e l o d e l 3 0 2 - - - - 4 W 3 0 2 3 0 2 4 W ＞ ＞ ＞ ＞ 4 W 4 W
Then make a
For
7
＜ ＜ ＜ ＜ M M M M o d e l o d e l ： ： ： ： 3 0 2 o d e l o d e l 3 0 2 - - - - 5 W 3 0 2 3 0 2 5 W ＞ ＞ ＞ ＞ 5 W 5 W