How To Install The Machine; Timing Of The Looper To The Needles; Angle For Installing The Looper And Position Of The Looper Holder Bracket - KANSAI SPECIAL BX Series Instructions Manual

5 5 5 5 - - - - 2 How to install the machine

2 How to install the machine 2 How to install the machine 2 How to install the machine
Install the brackets on the underside of the table board (see the illustration below).
Fit the rubber cushions onto the brackets.
Mount the machine head on the rubber cushions.
【6】TIMING OF THE LOOPER TO THE NEEDLES

6 6 6 6 - - - - 1 Angle for installing the looper and position of the looper holder bracket

1 Angle for installing the looper and position of the looper holder bracket
1 Angle for installing the looper and position of the looper holder bracket 1 Angle for installing the looper and position of the looper holder bracket
Insert the looper into the looper holder until bottom A of the looper touches looper holder
bracket B. Then tighten screw C. When the looper passes the needle, there should be a
clearance of 0~0.1mm between the point of the looper and the scarf of the needle.
Adjustment is made by loosening screw D and moving the looper holder bracket left or
right.
12