Machine Speed; Machine Speed & Direction In Which The Machine Pulley Runs; Motor & Belt - KANSAI SPECIAL HDX Series Instruction

【2】MACHINE SPEED
2-1 Machine speed & direction in which the machine pulley runs
Refer to the table below for maximum and standard
speeds of the Series. To extend machine life, run
the machine approximately 15-20% below the
maximum speed for the first 200 hours of operation
(approx. 1 month). Then run the machine at the
standard
clockwise as seen from the end of the machine
pulley.
2-2 Motor & belt
Motor : 3-phase，2-pole，400W clutch motor
Belt : M type V belt
Select the proper motor pulley according to the
machine speed (refer to the motor pulley outer
diameter on the table below).
position the motor by pressing the finger onto the
middle of the belt so that 1~2cm deflection can be
obtained (see the illustration on the right).
< Machine speed >
Type
HDX1101
HDX1102
< Motor pulley selection table >
Motor pulley
outer diameter
(mm)
60
70
80
90
speed. The machine
Maximum speed
3000SPM
3000SPM
Machine speed (SPM)
50Hz
2500
2900
3300
3700
pulley turns
Adjust where to
Standard speed
2500SPM
2500SPM
60Hz
2950
3450
3900
4400
2
H D X
H D X
s e r i e s
s e r i e s