Table of Contents
Advertisement
Chapter 4
Configuring Layer 3 Interfaces
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Command
show interface loopback number counters
detailed [all]
show interface loopback number counters
errors
show interface vlan number counters
show interface vlan number counters detailed
[all]
show interface vlan number counters snmp
See the Cisco Nexus 7000 Series NX-OS Interfaces Command Reference, Release 5.x, for information on
these commands.
Configuration Examples for Layer 3 Interfaces
This example shows how to configure Ethernet subinterfaces:
interface ethernet 2/1.10
This example shows how to configure a VLAN interface:
interface vlan 100
ipv6 address 33:0DB::2/8
This example shows how to configure a loopback interface:
interface loopback 3
ip address 192.0.2.2/32
Related Topics
The following topics can give more information on Layer 3 interfaces:
•
•
Additional References
For additional information related to implementing Layer 3 interfaces, see the following sections:
•
OL-23435-03
description Layer 3 for VLAN 10
encapsulation dot1q 10
ip address 192.0.2.1/8
Chapter 6, "Configuring Port Channels"
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 5.x
Related Documents, page 4-20
Purpose
Displays the loopback interface statistics. You
can optionally include all 32-bit and 64-bit packet
and byte counters (including errors).
Displays the loopback interface input and output
errors.
Displays the VLAN interface input and output
counters (unicast, multicast, and broadcast).
Displays the VLAN interface statistics. You can
optionally include all Layer 3 packet and byte
counters (unicast and multicast).
Displays the VLAN interface counters reported
by SNMP MIBs. You cannot clear these counters.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
Configuration Examples for Layer 3 Interfaces
4-19
- Quick Links:
- Enabling Lacp
Hide quick links:
Advertisement
Chapters
Table of Contents
