Telephone System Features; Headsets; Intercom Calls; Placing Intercom Calls - Inter-Tel 5.2 Phone User Manual

Telephone System Features

H
EADSETS
For convenience, you can connect an electret headset to your phone. If your headset
has a power-saver mode, make sure the System Administrator has the Headset Con-
nect Tone flag enabled in the telephone system. If this flag is disabled, you may miss
portions of incoming calls.
To connect a headset:
— Unplug the coiled handset cord from the base of the telephone. (Leave the hand-
set in the cradle.)
— Insert the headset plug into the vacant handset jack.
— While on hook, enter the Headset On feature code (
Off feature code (
To disconnect a headset:
— Unplug the headset cord from the base of the phone.
— Plug the coiled handset cord into the vacant jack.
— While on hook, enter the Headset Off feature code (
Off feature code (
NOTE:
If using a headset, press the SPKR key to connect and disconnect calls.
I C
NTERCOM ALLS

Placing Intercom Calls

The Basics
To place an intercom call:
— With or without the handset lifted, dial an extension number.
— If your call goes through handsfree to a phone's speaker, speak after you hear a
double tone.
If you hear continuous ringing, wait for the call to be answered.
8
). Display phones will show HEADSET MODE ON.
3 1 7
). Display phones will show HEADSET MODE OFF.
3 1 7
Eclipse Associate Display and Basic Digital Phone User Guide
) or the Headset On/
3 1 5
) or the Headset On/
3 1 6