Battery Preparation (Except Battery Without Maintenance); Installing The Battery - Peugeot Motorcycles Citystar 125i Workshop Manual

Battery preparation (Except battery without maintenance)*

Remove the battery.
Remove the 6 filler caps and the vent plug.
Fill all the battery cells with electrolyte to the upper level shown on the battery "UPPER LEVEL".
Electrolyte: (35% sulfuric acid = 1.28g/cm3). 0.5 litre can P/N 739733.
Leave the battery to stand for around half an hour.
Top up if necessary.
Charge the battery for at least 2 hours with a current of 1.2 A.
Then, the battery level should be topped up if necessary, after fully charging, using distilled water only.
* Depending on equipment.

Installing the battery

- Connect the battery breather hose to the
battery.
- Insert the end of the hose into the opening in
the battery compartment.
- Place the hose in the battery compartment
guide channel.
- Fit the battery in its housing.
- Pull gently on the hose to avoid it being
pinched.
- Insert the hose into the hasps inside the mud
guard.
- Connect the red wire lug to the battery's +
terminal, and the green wire lug to the
battery's - terminal.
- Fit the battery retention plate.
- Fit the retention strap.
- Fit the battery access hatch.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
SERVICE SCHEDULE AND COMMISSIONING
11