Checking The Valve Clearance; Changing The Fuel Filter - Peugeot Motorcycles Citystar 125i Workshop Manual

- If the clearance is not correct, adjust by means
of the cam follower screw.
- Use a wrench to adjust the valve clearance:
Type: Marolotest, P/N 500140.

Checking the valve clearance

- At the intake a 0.15 mm feeler gauge
shouldn't go.
- At the exhaust a 0.25 mm feeler gauge
shouldn't go.
- On the contrary, if the fealer gauge goes,
reset the clearances.

Changing the fuel filter

The fuel filter is incorporated into the
pump.
- Remove the footboard. See: Procedure 7.
page 27.
- Carry out the procedure for lowering the
pressure in the fuel system. See:
Procedure 8. page 63.
- Disconnect the fuel supply hose (1).
- Remove the fuel filter (3 screw).
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
SERVICE OPERATIONS
A
47