Service Operations; Changing The Engine Oil And Replacing The Oil Filter - Peugeot Motorcycles Citystar 125i Workshop Manual

SERVICE OPERATIONS

SERVICE OPERATIONS
Changing the engine oil and replacing
the oil filter
The engine must be drained when it is
warm to allow the oil to run easier.
Wear gloves in order not to get burnt.
- Place the vehicle on its central stand on flat
ground.
- Remove the engine's oil filler cap.
Remove the cap and the filter to drain
oil from the engine (1).
N
Replace the copper seal every time you
change oil.
- Remove the fairing under the saddle (Left
side) See: Procedure 2. page 23.
- Remove the filter cover (2 screw).
- Remove the oil filter.
Check the condition of the O-ring and
change it if necessary.
- Install a new oil filter and its cover.
Tightening torque: 10 Nm.
28
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
1