Removal Of The Footboard - Peugeot Motorcycles Citystar 125i Workshop Manual

- Remove the header tank (2 screw) (Right side).
- Remove the ingnition switch trim (1).
- Remove the utility hanger (2) (2 screw).
- Disconnect the accessory plug (3).
- Remove the rear shield panel.
• 1 washer head screws Ø5 mm (F).
• 2 washer head screws Ø6 mm (G).

Removal of the footboard

Procedure 7.
- Remove the under-saddle panels. See:
Procedure 2. page 23.
- Remove the rear shield panel. See:
Procedure 2. page 23.
- Remove the RH and LH under body panel.
• 3 plastic screws (A).
• 2 screw Ø6 mm (B).
- Remove the footboard.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
3
G
A
BODY PANELS
1
2
F
G
B
27