The Fork And Its Components - Peugeot Motorcycles Citystar 125i Workshop Manual

The fork and its components

1. Fork tube cap.
2. Spring.
3. Screw and copper seal.
4. Hollow shaft.
5. End of compression cone.
6. Fork upper tube.
7. Washer.
8. Retaining clip.
9. Balk rings
10. Tightness seal.
11. Dust cover.
12. Expansion spring.
13. Calibrated hydraulic tube.
14. Fork triple clamp.
Pre-assembly checks
- Clean all the parts with a degreasing agent:
• Biosane type ref. 754748.
• Or use an ultrasonic cleaning tank.
- Check the condition of the fork tube, there shall be no corrosion or impact marks, and the tube
shall be perfectly straight and clean.
Reassembly
- Install a new guiding ring (1).
- Install the expansion stop spring (2).
- Install the calibrated hydraulic tube (3).
- Install the compression stop cone (4) on the
calibrated hydraulic tube.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
8
7
6
13
12
5
4
14
3
3
2
STEERING/FORK
2
1
10
9
9
4
1
11
55