STEERING/FORK
Installing the fork
- Grease the cup bearing races.
- Install new ball cage bearings (7) (respect the
right way of installation).
- Fit the fork into the steering column.
- Install new ball cage bearings (8) (no special
direction).
- Install the adjustable cone and tighten it (5).
Tightening torque: 20 Nm.
- Loosen and then retighten the adjustable
cone.
Tightening torque: 20 Nm.
Do not tighten the adjustment cone
beyond the recommended value to
avoid damaging the steering bearings.
- Install the rubber washer (4).
- Fit and finger tighten the nut (3) so that its
notches are aligned with those of the nut.
- Fit the lock washer (2) in the notches of the
locknut and adjustable cone.
- Install the steering head locknut and tighten it.
Tightening torque: 75 Nm.
- Check that there is no play in the fork.
- Turn the fork from left to right to check that
there are no tight spots.
- Refit the other items in the reverse order to
disassembly.
62
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
7
5
3
8
2
4