Refitting The Clutch Lining Assembly - Peugeot Motorcycles Citystar 125i Workshop Manual

SERVICE OPERATIONS
- Compress the clutch and driven pulley
assembly using tool 758008 equipped with
the protection spacer P/N 801412.
- Remove nut (1) using spanner P/N 754040.
- Slacken tool P/N 758008.
- Remove the clutch linings (2), the upper
centring sleeve (3), the spring (4), and the
lower centring sleeve (5).
- Remove the 3 pins (6) from the variable
speed drive seat.
- Separate the fixed (7) and rotating (8) flanges.
- Make sure surface of the plates in contact with
the belt does not show any cracks or signs of
abnormal wear.

Refitting the clutch lining assembly

- Make sure surface of the plates in contact with
the belt does not show any cracks or signs of
abnormal wear (A).
- After checking the 2 lip seals (9) and the 2 O-
rings (10) of the rotating flange (8) are in good
condition, grease the governor seat 3 pins (6)
(high temperature grease) and assemble the
parts in reverse order to removal.
40
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
758008
1 2 3
6
9
10
754040
801412
4
7
8
A
8
5