Installing The Primary Drive - Peugeot Motorcycles Citystar 125i Workshop Manual

Installing the primary drive

Before fitting the clutch drive pulley and
driven pulley to the input shaft, fit the
belt into the pulley bottom by opening
the flanges by hand.
Respect the direction of rotation of the
belt which is shown by an arrow.
- Lightly grease the drawn cup needle roller
bearing of the driven pulley.
- Fit the clutch drive pulley and driven pulley
assembly.
- Fit the drive pulley with its guide hub onto the
connecting rod (1).
- Fit the belt (2) to the guide hub.
- Fit the fixed flange (3) to the crank assembly,
ensuring that it is properly positioned on the
crank assembly splines and checking that it is
in contact with the hub guide of the mobile
flange.
- Fit and tighten the nut.
Tightening torque:
• 125 cc: 70 Nm.
• 200 cc: 110 Nm.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
3
752237
SERVICE OPERATIONS
2
43