Initial Configuration; Accessing The Dxi4500, Remote Management Console - Quantum DXi4510 Installation And Configuration Manual

Figure 8 Cabling the DXi4500
Back
Not used

Initial Configuration

Accessing the DXi4500,
Remote Management
Console
Initial Configuration
2
Gb 1
Gb 2
Service ports (not
for customer use)
Not used
Before the DXi4500 is operational, you must configure the system through the remote
management console. You must also configure your backup software.
Configuring the DXi4500 consists of four major steps. See the following subsections for
detailed instructions for completing each step:
1

Accessing the DXi4500, Remote Management Console

2 Completing the Getting Started Wizard
3 Connecting the Ethernet Cables
4 Creating a Typical Backup Configuration
Note: You will need a computer and an Ethernet cable to complete the initial setup.
Note: If you attempt to install multiple DXi4500 systems at the same time, an IP
address conflict can occur because each system is configured with the same
default IP address (10.1.1.1). To avoid this problem, install one system and
configure it to use a different IP address before you connect another system to
the network.
To access the DXi4500 remote management console:
1 Turn on the DXi4500 system by pressing the power button located on the front of
each chassis (see Figure
1
3 4 5
2
3
on page 14
on page 19
on page 20
9).
DXi4500
1
2
Power cables
on page 11
11