Quantum DXi4510 Installation And Configuration Manual page 18

DXi4500 Installation and Configuration Guide
Figure 17 Getting Started
Wizard: Confirm
18
9 If necessary, select Manual Date & Time Settings to manually set the system date
and time.
Specify the New System Date by clicking Calendar. Specify the New System Time
using the drop-down boxes.
Note: You can also choose to synchronize the system time with an NTP time
server. To select a timeserver pool, you must have specified at least one DNS
IP address in step 5d above. Otherwise, you must specify the IP address of
the timeserver pool. For more information, see the Quantum DXi4500
User's Guide (6-67083) located on the documentation CD.
10 In the Timezone drop-down box, select the time zone where the DXi4500 is located.
11 Next to Time Format, select the format to use when displaying times (24 hours or
12 hours).
12 Click Next to continue.
The Confirm page displays (see
13 Review the settings you selected to make sure they are correct. If necessary, click
Previous to return to a previous step to make changes
14 After you have confirmed all settings, click Finish.
A message appears stating that completing the setup will restart the system.
15 Click Yes to restart the system.
16 Disconnect the computer from the DXi4500. Reset the computer network settings
back to its default values.
17 Wait 30 minutes for the system to fully restart.
Continue with the next section to create a typical backup configuration.
Figure 17).
Initial Configuration