Quantum DXi4510 Installation And Configuration Manual page 22

DXi4500 Installation and Configuration Guide
Figure 20 NAS Wizard: About
22
Note: This procedure assumes you are creating a NAS share in a Windows
environment. Refer to the Quantum DXi4500 User's Guide (6-67092) located
on the documentation CD for additional NAS configuration information.
1 Log on to the DXi4500 remote management console:
a On a computer on the same subnet as the DXi4500, enter the IP address of the
system in the Address box of a supported Web browser.
Use the IP address you specified when setting up the system.
The Login window displays (see
b Select Administrator, type password for the password, and click Login.
If this is the first time you have logged on since completing the Getting Started
wizard, then the Configuration Wizards page displays. Otherwise, the Home
page displays.
2 Access the NAS wizard:
Note: This procedure assumes you are joining the DXi4500 to a Windows
workgroup. If your site uses Active Directory instead of workgroups, refer
to the Quantum DXi4500 User's Guide (6-67092) located on the
documentation CD for information on joining a Windows domain using
Active Directory.
a If the Wizards menu is not visible, click Wizards on the main menu.
b On the Wizards menu, click NAS.
The About page displays (see
3 Read the information about the wizard, and then click Next to continue.
The Protocol page displays (see
Figure 12).
Figure 20).
Figure 21).
Initial Configuration