Environmental Conditions; Preparing For The Installation; Necessary Tools; Taking Esd Precautions - Quantum DXi4510 Installation And Configuration Manual

Environmental
Conditions

Preparing for the Installation

Necessary Tools

Taking ESD Precautions

Preparing for the Installation
Weight (stand alone)
Air Clearance
The installation site must have the following environmental conditions:
• Humidity: 20% to 80% (non-condensing)
• Temperature: 10 to 35 °C (50 to 95 °F) 35 °C Max, Altitude = 900 m or 2952.75 ft
(28 °C Max, Altitude = 3048 m or 10,000 ft)
These environmental conditions apply when the DXi4500 system is in operation.
Note: For additional specifications, refer to the Quantum DXi4500 User's Guide (6-
67092) located on the documentation CD.
Before you begin the installation procedure in this section, make the following
preparations as described in this section:
• Necessary Tools on page 3
• Taking ESD Precautions
Provide the following tools for unpacking and installing the DXi4500:
• #2 PHILLIPS screwdriver
• Notebook PC (for setting up initial system configuration)
Some components within the DXi4500 system contain static-sensitive parts. To avoid
damaging these parts while performing installation procedures, always observe the
following precautions:
• Keep the DXi4500 system turned off during all installation procedures.
• Keep static-sensitive parts in their original shipping containers until ready for
installation.
• Do not place static-sensitive parts on a metal surface. Place them inside their
protective shipping bag or on an antistatic mat.
• Avoid touching connectors and other components.
DXi4500
49.5 lbs (22.5 Kg)
Open 4 in (10.2 cm) behind unit for proper air flow
on page 3
DXi4500
3