DX3000 and DX5000 Quick Start Guide
Figure 11 DX3000 System
Cabling
Fibre Channel ports (optional Optyon™ card)
Power supply cables
Cabling a DX5000 System
Connect the following cables to the back of the DX5000
system (see
figure
12):
•
Connect a power cable to each power supply
•
Connect an Ethernet cable to port ETH1(left-hand port)
•
Fibre Channel cable (optional)
Figure 12 DX5000 System
Cabling
Ethernet ports
Power supply cables
Initial Configuration
Before the DX3000/DX5000 is operational, you must
configure the system by completing the remote
management setup screens.
1 2
Ethernet ports
0
Fibre Channel ports (optional
Optyon™ cards)
1 2
Configuring the DX3000/DX5000 consists of the following
major steps:
•
Accept the License Agreement
•
Complete the User Registration
•
Complete the Network Configuration
•
Select a RAID Configuration
•
Create Cartridges on the DX3000/DX5000
To configure the DX3000/DX5000:
1 Turn on the D3000/DX5000 system by pressing the
power button located on the front of the chassis (see
figure
13).
Figure 13 Power Buttons
2 On a computer on the same subnet as the DX3000/
DX5000, enter the IP address of the system in the
Address field of a web browser.
N
: The default IP address is: 10.1.1.1 for port 1
OTE
and 10.0.1.0 for port 2.
The Log In screen displays (see
0
Power button
Power button
figure
14).
8