Table of Contents
Advertisement
Chapter 2: Getting Started with the Standard Interface
The Quick Start Tutorial
This tutorial gives you step-by-step instructions on how to perform basic tasks
using the debugger.
Perform the tasks in the sequence given; otherwise, your results may not be
the same as those shown here.
Some values displayed on your screen may vary from the values shown here.
The exercises and displays in this chapter were made using a HP 64747
40 MHz 68030/EC030 emulator. If you are using an emulator with a different
clock rate or the HP 64748 68020 emulator, the information displayed in some
windows on your screen will be different.
Before You Begin
This chapter assumes you have already installed the debugger as described in
the "Installation" chapter.
The emulator name emul68k is used in the examples in this chapter. If you
have given your emulator a different logical name in the HP 64700 emulator
device table /usr/hp64000/etc/64700tab.net, use your emulator name or lan
address in the examples. See the HP 64700A Card Cage Installation/Service
Manual for detailed information on installing your emulator.
Note
Some commands are printed on two lines in this chapter. When entering
these commands, type the entire command on one line.
The Demonstration Program
The demonstration program used in this chapter is a simple environmental
control system (ECS). The system controls the temperature and humidity of a
room requiring accurate environmental control. The program continuously
looks at flags which tell it what action to take next.
40
Advertisement
Table of Contents
