Table of Contents
Advertisement
The debugger will begin executing commands found in the command file as if
those commands were entered directly into the interface. The debugger will
continue to execute commands until it reaches the end of the file or, perhaps,
until an error occurs, depending on the command file error handling mode
(see "To set command file error handling").
To interrupt playback of a command file, press the < Ctrl> -c key combination.
(If the graphical interface is being used, the mouse pointer must be within the
interface window.)
Example
To start executing command from the file "cmdfile1.com":
File Command cmdfile1
To set command file error handling
• Using the command line, enter:
File Error_Command <Handling_Mode>
Select either Abort_Read, Continue_Read, or Quit_Debugger error handling
mode, and press the < Return> key.
When an error occurs while executing a command file:
Abort_Read
Continue_Read causes the debugger to continue executing the command file
Quit_Debugger
Chapter 8: Using Macros and Command Files
causes the debugger to stop reading the command file.
with the next command.
causes the debugger session to end.
Using Command Files
241
Advertisement
Table of Contents
