Table of Contents
Advertisement
Chapter 10: Configuring the Emulator
Emulator Configuration Items
reset vector addresses. In the emulation configuration questions, you will
specify the appropriate values for the stack pointer and program counter so
that they can be supplied by the emulator when they can't be fetched from the
reset vector addresses.
To enter the monitor after configuration
You can allow the emulator to remain in the reset state after you complete the
configuration process, or you can have it begin executing in the monitor.
• In the "General Items" configuration section, answer the question:
Enter monitor after configuration?
yes
no
296
means that the emulator will break to the monitor (from
reset) when you finish the configuration session. (This is the
default.)
means that the emulator will remain reset when you finish
the configuration session.
Advertisement
Table of Contents
