Table of Contents
Advertisement
Chapter 12: Debugger Commands
Memory Block_Operation Match
Memory Block_Operation Match
The Memory Block_Operation Match command compares the contents of two
blocks of memory to determine their similarities or differences. The command
compares the block of memory specified by the address range
< addr> ..< addr> with the same size block starting at < addr> .
The debugger displays differences between the two blocks of memory,
mismatched values and addresses, in the Journal window. If the contents of the
two blocks of memory are the same, the debugger displays the message
Memory blocks are the same.
The Memory Block_Operation Match Stop_On_Mismatch command halts
when a mismatch is found. If the Memory Block_Operation Match
Repeat_On_Mismatch command is selected, the comparison continues until
the end of the block.
When you execute the Memory Block_Operation Match
Stop_On_Mismatch/Repeat_On_Mismatch command without specifying an
address range, the debugger continues comparing the address range specified
in the previous Memory Block_Operation Match Stop_On_Mismatch
command starting from where it found the last mismatch.
See Also
Memory Block_Operation Copy
Memory Block_Operation Fill
Memory Block_Operation Search
Memory Block_Operation Test
431
Advertisement
Table of Contents
