Step 1: Install The Software; Step 2: Map Your Function Keys - HP B1476 68020 User Manual

Step 1: Install the software

For instructions on how to install software on your SPARCsystem, refer to the
HP 64000-UX for SPARCsystems— Software Installation Guide.
Normally you should install all of the filesets on the tape. If you do not wish to
install the graphical interface, install everything except the XUI suffixed
filesets. This will save about 3.5 megabytes of disk space.

Step 2: Map your function keys

If you are using the character-based Standard Interface, map your function
keys by following the steps below:
1 Copy the function key definitions by typing:
cp $HP64000/etc/ttyswrc ~/.ttyswrc
This creates key mappings in the .ttyswrc file in your $HOME directory.
2 Remove or comment out the following line from your .xinitrc file:
xmodmap -e 'keysym F1 = Help'
If any of the other keys F1-F8 are remapped using xmodmap, comment out
those lines also.
3 Add the following to your .profile or .login file:
stty erase ^H
setenv KEYMAP sun
The erase character needs to be set to backspace so that the Delete key can be
used for "delete character."
To install the software on a Sun SPARCsystem™
Chapter 18: Installation
625