Each target system differs in the way it uses the processor, memory, and
memory mapped I/O devices. During system development, your needs for
emulator resources may change as your target system design matures. You can
allocate emulator resources using debugger commands. This resource
allocation is called the emulator configuration.
There are three ways to configure the emulator:
•
•
•
The Emulation Configuration dialog box is available both in the
debugger/emulator graphical interface and in the emulator/analyzer graphical
interface.
284
Load a configuration file into the emulator.
Change the configuration using the Emulator Configuration dialog box.
Change the configuration using the Debugger Execution Environment
Modify_Config command from the command line.